89-91 SiR CR-X/Civic Mugen bumper - Where can I purchase an original or a copy?

[hondastaR]

I have looked everywhere!  I cannont find any company that makes a copy of it.  I am planning on doing the SiR conversion on my newly acquired 88 Hatch.  I want this bumper or a copy that incorporates the wrap around turn signals.

Observation:  From what I have seen the Wings West kit is a copy of the Mugen Si bumper.  The main difference is, it uses the short turn signals on the front.  What about cuting the urethane for the SiR turn Signals?  Would it look accurate?  Does anyone know if the WW bumper will even bolt up to the SiR front end?
Any info is appreciated.

[88crx dx]

hey man good news go to this site and see what i mean
http://cgi.ebay.com/ebaymot....r=0&t=0

[steel]

Dont expect to do the Mugen.  You wont be able to find it anywhere and I know I have looked.  But I talked to one guy that sold his the front bumper alone can go for over 1,000.  This is common since the kit is not made anymore and was only readily available in Japan.  #### people.

[MikeShiesty]

Yeah, Mugen is too expensive and too difficult to find. It is practically impossible (well, i'm sure it's possible but difficult) to mold the wrap around turn signals onto urethane. But i do have one suggestion though. Either find a fiberglass copy, or any other fiberglass front bumper and mold prelude or integra turn signals to it. It'll be a whole lot cheaper and still look just as good.

[masta shark]

no, the ww kit wont bolt up to the SiR front end, so even if you have the lights molded on, it wont fit the hood and lights properly.